Vehicle Dynamics Control operation indicator light

It blinks when the skid suppression function is activated. It illuminates only when the traction control function is operating.

It blinks when the skid suppression function is activated. It illuminates only when the traction control function is operating.

The Vehicle Dynamics Control system is probably malfunctioning under any of the following conditions. Have your vehicle checked at a SUBARU dealer immediately.

• The light does not illuminate when the ignition switch is turned to the “ON” position.

• The light does not turn off even after a period of approximately 2 seconds after the ignition switch has been turned to the “ON” position.

    See also:

    Rear seat center table (if equipped)
    To use the rear seat center table, pull the strap up. The rear seat center table can be used as a storage space and as rear passenger’s cup holders. - Do not step or sit on the rea ...

    Front turn signal light
    NOTE It may be difficult to replace the bulbs. We recommend that you have the bulbs replaced by your SUBARU dealer if necessary. 1. Turn over the protective cover of the engine compartment. 2 ...

    Air inlet selection button
    Air inlet selection button ON position (Recirculation): Interior air is recirculated inside the vehicle. Push the air inlet selection button to the ON position. The indicator light will illu ...