Moonroof – if moonroof cannot be closed
If the moonroof cannot be closed with the moonroof switch, you can close the moonroof manually.
1. Take out the screwdriver from the tool bucket.
2. Open the overhead console. Refer to “Overhead console” F6-8.
3. Remove the two screws that retain the moonroof switch body. Then, remove the moonroof switch.
4. Insert the hex-head wrench in the end of the motor shaft.
To lower the moonroof, turn the wrench clockwise.
To close the moonroof, turn the wrench counterclockwise.
Have your vehicle checked and repaired by an authorized SUBARU dealer.
See also:
California fuel
If your vehicle was certified to California Emission Standards as indicated on
the underhood tune-up label, it is designed to optimize engine and emission control
system performance with gasoline ...
Reclining the seatback (Outback)
WARNING
To prevent the passenger from sliding under the seatbelt in the event of a collision,
always put the seatback in the upright position while the vehicle is in motion.
CAUTION
If the vehi ...
Most common causes of corrosion
The most common causes of corrosion
are:
1. The accumulation of moisture retaining
dirt and debris in body panel sections,
cavities, and other areas.
2. Damage to paint and other protective
...