High beam light bulbs
Right-hand side
1. Use a screwdriver to undo the clips on the air intake duct, then remove the air intake duct (right-hand side).
2. Disconnect the electrical connector from the bulb.
3. Remove the bulb from the headlight assembly by turning it counterclockwise.
4. Replace the bulb with new one. At this time, use care not to touch the bulb surface.
5. To install the bulb to the headlight assembly, turn it clockwise until it clicks.
6. Reconnect the electrical connector.
7. Install the air intake duct with clips (right-hand side).
See also:
Combination meter illumination
When the ignition switch is turned to the “ON” position, the various parts of the combination meter are illuminated in the following sequence:
Turbo models:
1. Warning lights, indicator lights, mete ...
Air conditioner compressor shut-off when engine is heavily loaded
To improve acceleration and gas mileage, the air conditioner compressor is designed
to temporarily shut off during air conditioner operation whenever the accelerator
is fully depressed such as dur ...
Reclining the seatback
WARNING
To prevent the passenger from sliding under the seatbelt in the event of a collision,
always put the seatback in the upright position while the vehicle is in motion.
Also, do no ...