To increase the speed (by accelerator pedal)

1. Depress the accelerator pedal to accelerate the vehicle to the desired speed.

2. Push the “SET/COAST” button once.

Now the desired speed is set and the vehicle will keep running at that speed without depressing the accelerator pedal.

NOTE
If the difference between the actual vehicle speed when the button is pushed and the speed last time you set is less than 4 mph (6.8 km/h), the vehicle speed will be lowered by 1 mph (1.6 km/h). This occurs because the cruise control system unit regards this operation as that intended to decrease the vehicle speed.

    See also:

    System setup
    You can select the following menus only by operating the “TUNE/TRACK/CH” dial. ...

    Changing a flat tire
    WARNING ● Do not jack up the vehicle on an incline or a loose road surface. The jack can come out of the jacking point or sink into the ground and this can result in a serious accident. &# ...

    Air inlet selection button
    Air inlet selection button ON position (recirculation): Interior air is recirculated inside the vehicle. Push the air inlet selection button to the ON position. The indicator light will illuminate. ...