Displaying satellite radio ID of tuner

When you activate satellite radio, you should have your satellite radio tuner ID ready because each tuner is identified by its unique satellite radio tuner ID.

The satellite radio ID will be needed when you activate satellite radio and receive satellite radio customer support.

The satellite radio ID can be found on the audio display by tuning the channel to “0”.

Turn the “TUNE/TRACK/CH” dial to select the satellite radio channel.

NOTE
For Sirius, change the display to an indication mode other than the channel number after performing the above operation.

    See also:

    Maximum allowable speeds
    WARNING When shifting down a gear, ensure that the vehicle is not travelling at a speed exceeding the Maximum Allowable Speed for the gear which is about to be selected. Failure to observe this p ...

    BEEP setting
    A beep sound (operation sound) that occurs when the audio system is operated can be set ON/OFF. The initial setting is ON. ...

    Corrosion protection
    Refer to “Corrosion protection”. ...