Roof antenna

- Be sure to lower the antenna rod

- Be sure to lower the antenna rod before entering garages, parking towers and other locations with low ceilings.

- Remove the antenna rod before washing your car at a car wash. If the antenna rod is left attached, it may scratch the roof.

- When reinstalling the removed antenna rod, be sure to fully tighten it.

1) Unscrew

1) Unscrew
2) Remove

The roof antenna is installed in the center at the rear part of the roof.

It is possible to remove the antenna rod by unscrewing it from its base.

    See also:

    PTY (Program type) group selection
    In the PTY selection mode, press the following button to change the PTY group by one step at a time. Type A and B audio: Type C audio: This operation only changes the display. It does not ...

    Subaru Outback vs. Forester
    As the table reflects, the Outback starts at a higher price than the Forester but has slightly less cargo volume, and with the exception of 1 inch of front-seat legroom, it's smaller than the Fore ...

    Removing air intake duct
    Use a screwdriver to undo the clips on the air intake duct, then remove the air intake duct. Refer to “Type A clips” F11-5. ...