Compass calibration

1. If a “C” is displayed in the compass window, the compass needs to be calibrated.

2. Drive the vehicle in a circle at 5 mph (8 km/h) or less until the display reads a direction.

3. You can also calibrate the compass by driving your vehicle on your everyday routine. The compass will be calibrated once it has tracked a complete circle.

4. To recalibrate your compass, push and hold the compass display button for 9 seconds until a “C” appears in the compass window.

5. Calibrate the compass according to step 2 or step 3.

    See also:

    Gasoline for California-certified LEV
    If your vehicle was certified to California’s low emission vehicle (LEV) standards as indicated on the underhood tune-up label, it is designed to optimize engine and emission performance with gasoline ...

    START
    CAUTION Do not turn the ignition switch to the “START” position while the engine is running. The engine is started in this position. The starter cranks the engine to start it. When the key is rele ...

    Tether anchorage location
    Outback Three tether anchorages, i.e., ones for the right, center and left positions, are already installed on the rear edge of the roof. Open the cover flap to use each anchorage. ...