Headlight flasher
Headlight flasher
To flash the headlights, pull the lever toward you and then release it. The high beam will remain on for as long as you hold the lever. The headlight flasher works even though the light switch is in the “OFF” position.
When the headlights are on high beam,
the high beam indicator light “
” on
the
combination meter also illuminates.
Do not hold the lever in the flashing position for more than just a few seconds.
See also:
Cruise control indicator light
The cruise control indicator light illuminates when the ignition switch is turned
to the “ON” position and turns off after approximately 3 seconds.
This light illuminates when the “CRUISE” main s ...
Unlocking the doors
Press the “” button to unlock the
driver’s door. An electronic chirp will sound twice and the turn signal lights will
flash twice. To unlock all doors and the rear gate (Outback), briefly press ...
Speedometer
The speedometer shows the vehicle speed. ...