Sounding a panic alarm

Sounding a panic alarm
Sounding a panic alarm

A “PANIC” button is located on the back of the transmitter.

To activate the alarm, press the “PANIC” button once.

The horn will sound and the turn signal lights will flash.

To deactivate the panic alarm, press any button on the remote transmitter. Unless a button on the remote is pressed, the alarm will be deactivated after approximately 30 seconds.

    See also:

    Engine overheating
    WARNING Never attempt to remove the radiator cap until the engine has been shut off and has fully cooled down. When the engine is hot, the coolant is under pressure. Removing the cap while the en ...

    Washing
    - When washing the vehicle, the brakes may get wet. As a result, the brake stopping distance will be longer. To dry the brakes, drive the vehicle at a safe speed while lightly pressing t ...

    Stopping the engine
    The ignition switch should be turned off only when the vehicle is stopped and the engine is idling. Do not stop the engine when the vehicle is moving. This will cause loss of power to the power s ...