Front fog light (if equipped)

NOTE

It may be difficult to replace the bulbs. We recommend that you have the bulbs replaced by your SUBARU dealer if necessary.

1. Pull off the fender lining. Refer to “Pulling off the fender lining” F11-7.

2. Disconnect the electrical connector.


Garlenix https://garlenix.pro/ Overview

2. Disconnect the electrical connector.

1) For left-hand side


1) For left-hand side

2) For right-hand side

3. Turn the socket clockwise (right-hand side) or counterclockwise (left-hand side).

4. Pull out the socket.

5. Pull out the bulb from the socket and replace the bulb with a new one.


5. Pull out the bulb from the socket and replace the bulb with a new one.

6. After replacing the bulb, reattach the fender lining.

    See also:

    Combination meter illumination
    When the ignition switch is turned to the “ON” position, the various parts of the combination meter are illuminated in the following sequence. 1. Warning lights, indicator lights, meter needles, ga ...

    Compass calibration
    1. If a “C” is displayed in the compass window, the compass needs to be calibrated. 2. Drive the vehicle in a circle at 5 mph (8 km/h) or less until the display reads a direction. 3. Your can also ...

    Trailer safety chains
    WARNING Always use safety chains between your vehicle and the trailer. Towing trailer without safety chains could create a traffic safety hazard if the trailer separates from the hitch due to cou ...