Navigation monitor (if equipped)

To clean the navigation monitor, wipe it with a silicone cloth or with a soft cloth. If the navigation monitor is extremely dirty, clean it with a soft cloth moistened with neutral detergent then carefully wipe off any remaining detergent.

NOTE

● Do not spray neutral detergent directly onto the monitor. Doing so could damage the monitor’s components.

● Do not wipe the monitor with a hard cloth. Doing so could scratch the monitor.

● Do not use cleaning fluid that contains thinner, gasoline, or any other volatile substance. Such cleaning fluid could erase the lettering on the switches at the bottom of the monitor.

    See also:

    Ignition switch
    WARNING ● Never turn the ignition switch to “LOCK” while the vehicle is being driven or towed because that will lock the steering wheel, preventing steering control. And when the engine is ...

    Temperature A, B, C
    The temperature grades are A (the highest), B, and C, representing the tire’s resistance to the generation of heat and its ability to dissipate heat when tested under controlled conditions on a sp ...

    Rear gate (Outback) – if the rear gate cannot be unlocked
    In the event that you cannot unlock the rear gate by operating the power door locking switches or the remote keyless entry system, you can unlock it from inside the cargo area. 1. Remove the ac ...