Subaru Outback manuals

Subaru Outback (BR): Ejecting a CD from the player

Disc select buttons


Disc select buttons

1. Use the disc select button to select the disc to be ejected.

2. Briefly press the “” button. The


2. Briefly press the “selected disc will be ejected. The disc number indicator will flash at this time.” button. The
selected disc will be ejected. The disc number indicator will flash at this time. When you remove the ejected disc, the disc number indicator will turn off. To remove more discs in succession, repeat steps 1 and 2.

READ NEXT:

 Ejecting all discs from the player (all disc ejection mode)

1. If you press the “” button for 1.5 seconds or longer, the player will produce beep sound and will enter the all disc ejection mode. At this time, the disc number indicator and “ALL EJEC

 When the following messages are displayed

If one of the following messages is displayed while operating the CD player, determine the cause based on the following information. If you cannot clear those messages, please contact your SUBARU

 When “PUSH EJECT” is displayed

Press the eject button to unload the disc. Check the disc for damage or deformation, and also check that the correct disc is inserted. Do not try to unload the disc forcibly. Single CDs (i.e., 8 c

SEE MORE:

 Manual Transmission Mounting System

A: REMOVAL 1. CROSSMEMBER AND CUSHION RUBBER 1) Disconnect the ground cable from battery. 2) Lift up the vehicle. 3) Remove the front under cover. <Ref. to EI-35, REMOVAL, Front Under Cover.> 4) Remove the front and center exhaust pipes. (non-turbo model) <Ref. to EX(H4SO)-5, REMOVAL,

 Universal Joint

A: REMOVAL 1) Adjust the tilt position of the steering column to the lowest position and lock the tilt lever. 2) Prevent the steering wheel from turning using the seat belt. 3) Remove the universal joint. Place alignment marks on universal joint. Remove the universal joint bolt and remove the

© 2010-2024 Copyright www.suoutback.com