Snow tires
WARNING
● When replacing original tires with winter (snow) tires, make sure you use only the same size, construction and load range as the original tires listed on the tire placard. Using other sizes and construction may affect speedometer/ odometer calibration and clearance between the body and tires. It also may be dangerous and lead to loss of vehicle control.
● You must install four winter tires that are of the same size, circumferences, construction, brand, and load range. Mixing other sizes, circumferences or constructions may result in severe mechanical damage to the drive train of your vehicle and may affect ride, handling, braking and speedometer/odometer calibration. It also may be dangerous and lead to loss of vehicle control.
● Do not use a combination of radial, belted bias or bias tires since it may cause dangerous handling characteristics and lead to an accident.
See also:
Cruise control indicator light
The cruise control indicator light illuminates when the ignition switch is turned
to the “ON” position and turns off after approximately 3 seconds.
This light illuminates when the “CRUISE” main s ...
New front and rear suspensions
For the new Outback, Subaru has adopted a revised MacPherson strut front
suspension, with the lower arm mounted on the sub-frame for greater stability.
Steering response is enhanced, and quietness ...
High beam light bulbs
1. Remove the air intake duct (right-hand side). For the method to remove the
air intake duct, refer to “Removing air intake duct” F11-7.
Left-hand side
2. Use a screwdriver to remove the secure ...
