To increase the speed (by the “RES/ SET” switch)

Press the “RES/SET” switch to the “RES” side and hold it until the vehicle reaches


Press the “RES/SET” switch to the “RES” side and hold it until the vehicle reaches the desired speed. Then, release the switch. The vehicle speed at that moment will be memorized and treated as the new set speed.

U.S.-spec. models

When the difference between the actual vehicle speed and the set speed is less than 4 mph (6.8 km/h), the set speed can be increased 1 mph (1.6 km/h) each time by pressing the “RES/SET” switch to the “RES” side quickly.

Canada-spec. models

When the difference between the actual vehicle speed and the set speed is less than 4.4 km/h, the set speed can be increased 1 km/h each time by pressing the “RES/SET” switch to the “RES” side quickly.

    See also:

    Coolant temperature low indicator light/Coolant temperature high warning light
    CAUTION ● After turning the ignition switch to the “ON” position, if this indicator light/warning light behaves under any of the following conditions, the electrical system may be malfuncti ...

    Wheel alignment
    *: The differential between right-hand camber and left-hand camber should be within 45’ or less. ...

    Seatbelt warning light and chime
    Your vehicle is equipped with a seatbelt warning device at the driver’s and front passenger’s seat, as required by current safety standards. With the ignition switch turned to the “ON” po ...