Service mode

In service mode, the remote engine start function is temporarily disabled to prevent the system from unexpectedly starting the engine while being serviced.

To engage or disengage service mode:

1. Enter the vehicle and close all vehicle doors and the trunk/rear gate.

2. Verify that the select lever is in the “P” position (AT and CVT models) 3. Depress and hold the brake pedal 4. Turn the ignition switch to the “ON” position 5. Press and release the remote engine start transmitter “button three times. The system will honk the vehicle’s horn each time the button”
button three times. The system will honk the vehicle’s horn each time the button is pressed.

6. The system will pause for 1 second then honk the vehicle’s horn three times to indicate that the service mode has been engaged or honk one time to indicate that the service mode has been disengaged.

NOTE

When taking your vehicle in for service, it is recommended that you inform the service personnel that your vehicle is equipped with a remote engine start system.

    See also:

    How to use as crossbars
    CAUTION ● Do not raise the bar higher than necessary. The base of the bar may be damaged. ● Be careful not to contact the bars while sliding them. Otherwise, the bars may be scratched ...

    Initializing the registered data
    To initialize the registered data, perform the following procedure. 1. Select the “SETUP” menu. 2. Select the “SYSTEM SETUP” menu. 3. Select “INITIALIZE” by operating the “TUNE/TRACK/CH” dial. 4. ...

    Moonroof (if equipped)
    WARNING Never let anyone’s hands, arms, head or any objects protrude from the moonroof. A person could be seriously injured if the vehicle stops suddenly or turns sharply or if the vehicle is inv ...