Bi-level heating

This setting allows you to direct air of different temperatures from the instrument panel and foot outlets. The air from the foot outlets is slightly warmer than from the instrument panel outlets.

1. Set the air inlet selection button to the OFF position.

2. Press the “3. Set the temperature control dial to the desired temperature level.” button.


3. Set the temperature control dial to the desired temperature level.

4. Set the fan speed control dial to the desired speed.

Setting the temperature control dial fully turned to the red area or blue area decreases the temperature difference between the air from the instrument panel outlets and the air from the foot outlets.

    See also:

    Center console
    Center console To open the lid, pull up the lock release. ...

    Type D audio set (if equipped)
    Type D audio set (if equipped) The audio set will operate only when the ignition switch is in the “Acc” or “ON” position. - Power and audio controls: refer to page - Radio operation: refer t ...

    Entering the vehicle following remote engine start shutdown
    An alarm trigger may occur if the vehicle is opened by the remote keyless entry transmitter within a few seconds immediately following remote engine start shutdown. ...