Door open warning light

When the ignition switch is in the “ON” position, the door open warning light


When the ignition switch is in the “ON” position, the door open warning light illuminates for approximately 2 seconds and then turns off.

The door open warning light illuminates if any door, the rear gate (Outback) or trunk lid (Legacy) is not fully closed. This function is effective even if the ignition switch is in the “LOCK” or “Acc” position or the key is removed from the ignition switch.

Always make sure this light is not illuminated before you start to drive.

    See also:

    Programming for entrance gates and garage door openers in Canada
    1. Unplug the motor of the entrance gate or garage door opener from the outlet. NOTE If any of the HomeLink® buttons are already programmed for other devices, skip step 2 because it clears th ...

    “up” and “down” switch
    With radio mode selected Press the switch to the “” or “” side briefly to skip to a preset channel. Press the switch to the “” or “” side for more than 0.5 second to seek the next receivable ...

    Compass calibration
    1. If a “C” is displayed in the compass window, the compass needs to be calibrated. 2. Drive the vehicle in a circle at 5 mph (8 km/h) or less until the display reads a direction. 3. Your can also ...