Initialization of power window

Subaru Legacy / Subaru Legacy Owners Manual / Keys and doors / Windows / Initialization of power window

If the vehicle’s battery is disconnected due to situations such as battery or fuse replacement, the following functions are deactivated.

● One-touch auto up/down function ● Anti-entrapment function

Initialize the power window in the following procedure to reactivate such functions.

1. Close the driver’s door.

2. Turn the ignition switch to the “ON” position.

3. Open the driver’s side window halfway by pushing down the power window switch.

4. Pull up the power window switch and close the window completely. Continue pulling up the switch for approximately 1 second after the window is closed completely.

    See also:

    Selection of manual mode
    NOTE Please read the following points carefully and bear them in mind when using the manual mode. • If you attempt to shift down when the engine speed is too high, i.e., when a downshift would push ...

    Category selection
    Type A and B audio Type C audio To activate the category search mode, press the “PTY/CAT” button. To deactivate the category search mode, press the “PTY/CAT” button again. Type A and B audio Type ...

    Headlight flasher
    CAUTION Do not hold the lever in the flashing position for more than just a few seconds. To flash the headlights, pull the lever toward you and then release it. The high beam will stay on for as ...