Arming the system

CAUTION

In passive mode, the system will automatically activate the alarm but WILL NOT automatically lock the doors. In order to lock the doors you must either lock them as indicated in step 4 below or with the key once they have been closed. Failure to lock the doors manually will result in a higher security risk.

1. Turn the ignition switch to the “ON” position.

1) LOCK


1) LOCK
2) ON

2. Turn the ignition switch from “ON” to “LOCK” position and remove the key from the ignition switch.

3. Open the doors and get out of the vehicle.

4. Before closing the doors, lock all doors with the inside door lock levers.


4. Before closing the doors, lock all doors with the inside door lock levers.

5. Close the doors. The system will automatically arm after 1 minute.

In the passive mode, the system can also be armed with the remote transmitter or with the power door locking switches. If the remote transmitter or power door locking switch is used to lock the vehicle, arming will take place immediately regardless of whether or not the passive mode has been selected.

Disarming the system

To disarm the system, briefly press the “button on the transmitter.”
button on the transmitter.

    See also:

    Inserting a disc in a desired position
    1. Briefly press the button. If the magazine in the player has an idle position where you can insert a disc, the disc number indicator associated with the idle position will blink. The pos ...

    Light control and wiper control levers/switches
    1) Windshield wiper 2) Mist 3) Windshield washer 4) Rear window wiper and washer switch 5) Wiper intermittent time control switch 6) Wiper control lever 7) Light control switch 8) Fo ...

    When checking or servicing in the engine compartment
    Do not contact the belt cover while checking the components in the engine compartment. Doing so may cause your hand to slip off the belt cover and result in an unexpected injury. ...