Subaru Outback (BR): Windshield wiper blade assembly
1. Raise the wiper arm off the windshield.
1) Open the cover
2) Pull down the wiper blade
2. Remove the wiper blade assembly by opening the cover and pulling it down in
the direction shown in the illustration.
3. Install the wiper blade assembly to the wiper arm. Make sure that it locks in
place.
4. Hold the wiper arm by hand and slowly lower it in position.
READ NEXT:
1) Support
1. Grasp the locked end of the blade rubber assembly and pull it firmly until
the stoppers on the rubber are free of the support.
1) Metal spines
2. If the new blade rubber is not
1. Raise the wiper arm off the rear window.
2. Turn the wiper blade assembly counterclockwise.
3. Pull the wiper blade assembly toward you to remove it from the wiper arm.
1. Pull out the end of the blade rubber assembly to unlock it from the plastic
support.
2. Pull the blade rubber assembly out of the plastic support.
1) Metal spines
3. If the new blade rub
SEE MORE:
With radio mode selected
Press the switch to the “” or “”
side briefly to skip to a preset channel. Press the switch to the “”
or “” side for more than 0.5 second
to seek the next receivable station and stop at it.
That station’s frequency will be indicated on the audio d
A: REMOVAL
NOTE:
The illustration below is suitable for every model.
Perform the same procedures for the other models.
1) Remove the collector cover. (turbo model)
2) Remove the air intake boot assembly. (non-turbo
model) <Ref. to IN(H4SO)-8, REMOVAL, Air Intake
Boot.>
3) Remove the interc
© 2010-2024 Copyright www.suoutback.com