Subaru Outback (BR): Pulling off the fender lining
It is necessary to pull off the fender lining when replacing some bulbs.
1. Start the engine and turn the steering wheel fully in the opposite direction
of the bulb to be replaced.
2. Stop the engine.
3. Remove the clip from the fender lining. Refer to “Type B clips” F11-5.
4. Pull off the fender lining.
READ NEXT:
To open the hood:
1. If the wiper blades are lifted off the windshield, return them to their original
positions.
2. Pull the hood release knob under the instrument panel.
3. Release the secon
1) Power steering fluid reservoir (page 11-27)
2) Manual transmission oil level gauge (MT) (page 11-23)
3) Clutch fluid reservoir (page 11-29)
4) Brake fluid reservoir (page 11-28)
5) Fuse box (
SEE MORE:
If you press the “SCAN” button, the radio will switch to the scan mode. In this
mode, the radio scans through the radio band until a station is found. The radio
will stop at the station for 5 seconds while displaying the frequency, after which
scanning will continue until the entire band
WARNING
● Child restraint systems and seatbelts can become hot in a vehicle that has
been closed up in sunny weather; they could burn a small child. Check the child
restraint system before you place a child in it.
● Do not leave an unsecured child restraint system in your vehicle.
© 2010-2024 Copyright www.suoutback.com