Subaru Outback (BR): To increase the speed (by accelerator pedal)
1. Depress the accelerator pedal to accelerate the vehicle to the desired speed.
2. Press the “RES/SET” switch to the “SET” side once. Now the desired speed is set and the vehicle will keep running at that speed without depressing the accelerator pedal.
NOTE
● U.S.-spec. models
If the difference between the actual vehicle speed when the button is pressed and the speed last time you set is less than 4 mph (6.8 km/h), the vehicle speed will be lowered by 1 mph (1.6 km/h). This occurs because the cruise control system regards this operation as that intended to decrease the vehicle speed.
● Canada-spec. models
If the difference between the actual vehicle speed when the button is pressed and the speed last time you set is less than 4.4 km/h, the vehicle speed will be lowered by 1 km/h. This occurs because the cruise control system regards this operation as that intended to decrease the vehicle speed.
READ NEXT:
To decrease the speed (by the “RES/SET” switch)
Press the “RES/SET” switch to the “SET” side and hold it until the vehicle reaches
the desired speed. Then, release the switch. The vehicle speed at that moment will
be memorized and tre
To decrease the speed (by brake pedal)
1. Depress the brake pedal to release cruise control temporarily.
2. When the speed decreases to the desired speed, press the “RES/SET” switch
to the “SET” side once. Now the desired speed
Cruise control indicator light
The cruise control indicator light illuminates when the ignition switch is turned
to the “ON” position and turns off after approximately 3 seconds.
The light illuminates when the “CRUISE”
SEE MORE:
Basic Diagnostic Procedure of Automatic Transmission
A: PROCEDURE
Check List for Interview
A: CHECK
Check the following items when a problem has occurred.
NOTE: Use copies of this page for interviewing customers.
General Description
A: CAUTION
1. SUPPLEMENTAL RESTRAINT SYSTEM "AIRBAG"
The airbag system wiring harness is routed
DTC P0202, P0203, P0204, P0222, P0222, P0223, P0301, P0302, P0303, P0304,
P0327, P0328, P0335, P0336, P0340, P0341, P0351, P0352, P0353, P0354, P0400,
P0420, P0442, P0447, P0448, P0451, P0452
BA:DTC P0202 INJECTOR #2
NOTE:
For the diagnostic procedure, refer to DTC P0201. <Ref. to EN(H4SO)(diag)-162,
DTC P0201 INJECTOR
#1, Diagnostic Procedure with Diagnostic Trouble Code (DTC).>
BB:DTC P0203 INJECTOR #3
NOTE:
For the diagnostic procedure, refer to DTC P0201. <Ref. to EN(H4SO)(
