Subaru Outback (BR): Selecting reverse gear
CAUTION
Shift into reverse ONLY when the vehicle has completely stopped. It may cause
damage to the transmission to try shifting into reverse when the vehicle is moving.
1) Slider
You must raise the slider and hold it in that position before you can move the
shift lever to the “R” position.
To change gears, fully depress the clutch pedal, move the shift lever, and gradually
let up on the clutch pedal.
If it is difficult to shift into gear, put the transmission in neutral, release
the clutch pedal momentarily, and then try again.
READ NEXT:
The best compromise between fuel economy and vehicle performance during normal
driving is ensured by shifting up at the speeds listed in the following table.
WARNING
When shifting down a gear, ensure that the vehicle is not travelling at a speed
exceeding the Maximum Allowable Speed for the gear which is about to be selected.
Failure to observe this p
SEE MORE:
WARNING
Snow can trap dangerous exhaust gases under your vehicle. Keep snow clear of
the exhaust pipe and from around your vehicle if you park the vehicle in snow with
the engine running.
Do not use the parking brake when parking for long periods in cold weather since
it could freeze in that
Your vehicle comes equipped with P-Metric tire size. It is important to understand
the sizing system in selecting the proper tire for your vehicles. Here is a brief
review of the tire sizing system with a breakdown of its individual elements.
P Metric
With the P-Metric system, Section Width is
© 2010-2024 Copyright www.suoutback.com