Subaru Outback (BR): Displaying satellite radio ID of tuner
Subaru Outback (BR) 2010-2015 Owners Manual / Audio / Satellite radio operation (if equipped) / Displaying satellite radio ID of tuner
When you activate satellite radio, you should have your satellite radio tuner ID ready because each tuner is identified by its unique satellite radio tuner ID.
The satellite radio ID will be needed when you activate satellite radio and receive satellite radio customer support. The satellite radio ID can be found on the audio display by tuning the channel to “000”.
Turn the “TUNE/TRACK/CH” dial to select the satellite radio channel.
NOTE
For Sirius, change the display to an indication mode other than the channel number after performing the above operation.
READ NEXT:
Band selection
Press the “SAT” button when the radio is off to turn on the radio. Press the
“SAT” button when the radio is on to select SAT1, SAT2 or SAT3 reception.
Channel selection by operating the dial
Turn the “TUNE/TRACK/CH” dial clockwise to select the next channel and turn the
“TUNE/TRACK/CH” dial counterclockwise to select the previous channel.
SEE MORE:
Rear seats
WARNING
Seatbelts provide maximum restraint when the occupant sits well back and upright
in the seat. Do not put cushions or any other materials between occupants and seatbacks
or seat cushions. If you do so, the risk of sliding under the lap belt and of the
lap belt sliding up over the abd
Front Door Glass
A: REMOVAL
1) Remove the front door trim. <Ref. to EI-60, FRONT DOOR, REMOVAL, Door
Trim.>
2) Remove the sealing cover.
CAUTION:
Carefully remove the butyl tape. Excessive force will easily break
the cover.
If cover gets broken, replace it with a new part.
3) Remove the inner pad.
4)
© 2010-2024 Copyright www.suoutback.com
