Subaru Outback (BR): Vehicle Dynamics Control operation indicator light
The indicator light flashes during activation of the skid suppression function
and during activation of the traction control function.
NOTE
● The light may remain illuminated for a short period of time after the engine
has been started, especially in cold weather. This does not indicate the existence
of a problem. The light should turn off as soon as the engine has warmed up.
● The indicator light illuminates when the engine has developed a problem and the
CHECK ENGINE warning light/ malfunction indicator lamp is on. The Vehicle Dynamics
Control system is probably malfunctioning under the following condition. Have your
vehicle checked at a SUBARU dealer as soon as possible.
● The light does not turn off even after the lapse of several minutes (the engine
has warmed up) after the engine has started.
READ NEXT:
The light illuminates when the ignition switch is turned to the “ON” position
and turns off after approximately 2 seconds. The light illuminates when the Vehicle
Dynamics Control OFF switch
SEE MORE:
In service mode, the remote engine start function is temporarily disabled to
prevent the system from unexpectedly starting the engine while being serviced.
To engage or disengage service mode:
1. Enter the vehicle and close all vehicle doors and the trunk/rear gate.
2. Verify that the select le
● Promptly wipe the aluminum wheels clean of any kind of grime or agent. If dirt
is left on too long, it may be difficult to clean off.
● Do not use soap containing grit to clean the wheels. Be sure to use a neutral
cleaning agent, and later rinse thoroughly with water. Do not clean
© 2010-2024 Copyright www.suoutback.com