Subaru Outback (BR): Top tether anchorages
Your vehicle is equipped with three top tether anchorages so that a child restraint
system having a top tether can be installed in the rear seat. When installing a
child restraint system using top tether, proceed as follows, while observing the
instructions by the child restraint system manufacturer.
Since a top tether can provide additional stability by offering another connection
between a child restraint system and the vehicle, we recommend that you use a top
tether whenever one is required or available
READ NEXT:
Outback
Three tether anchorages, i.e., ones for the right, center and left positions,
are already installed on the rear edge of the roof. Open the cover flap to use each
anchorage.
CAUTION
Always remove the head restraint when mounting a child restraint system with
a top tether. Failure to do so may prevent the top tether from being fastened tightly.
Outback
1. Remove the
*SRS: This stands for supplemental restraint system. This name is used because
the airbag system supplements the vehicle’s seatbelts.
Your vehicle is equipped with a crash sensing and diagnostic
SEE MORE:
1. Remove the receiver cover from the hitch receiver tube. Then insert the ball
mount into the hitch receiver tube.
2. Insert the hitch pin into the hole on the hitch receiver tube so that the
pin passes through the ball mount.
3. Insert the safety pin onto the hitch pin securely.
4. Pull
1) Under-floor storage compartment (Refer to “Under-floor storage compartment” F6-18.)
2) Electronic parking brake release tool 3) Jack handle
4) Spare tire
5) Tool bucket
1) Wheel nut wrench
2) Screwdriver
3) Jack
4) Towing hook (eye bolt) (if equipped)
The
© 2010-2024 Copyright www.suoutback.com