Type A
1. Raise the wiper arm off the windshield.
1) Stopper
2. Remove the wiper blade assembly by holding its pivot area and pushing it in the direction shown by the arrow while depressing the wiper blade stopper.
3. Install the wiper blade assembly to the wiper arm. Make sure that it locks in place.
4. Hold the wiper arm by hand and slowly lower it in position.
See also:
The Inside
The interior is quiet enough at idle that one time I didn't even realize it
was running. That's when I recognized Subaru finally seems to have licked this
engine's chronic idle vibration. In this ...
Door open warning light
The door open warning light illuminates if any door or the rear gate is not fully closed.
Always make sure this light is not illuminated before you start to drive. ...
To set cruise control
1. Press the “CRUISE” main switch button.
The cruise control indicator light on the combination meter will illuminate.
2. Depress the accelerator pedal until the vehicle reaches the desired spee ...