Navigation monitor (if equipped)

To clean the navigation monitor, wipe it with a silicone cloth or with a soft cloth. If the navigation monitor is extremely dirty, clean it with a soft cloth moistened with neutral detergent then carefully wipe off any remaining detergent.

NOTE
• Do not spray neutral detergent directly onto the monitor. Doing so could damage the monitor’s components.

• Do not wipe the monitor with a hard cloth. Doing so could scratch the monitor.

• Do not use cleaning fluid that contains thinner, gasoline, or any other volatile substance. Such cleaning fluid could erase the lettering on the switches at the bottom of the monitor.

    See also:

    Cooling or dehumidifying
    Cooling or dehumidifying 1) ON position For cooling and dehumidification of the passenger compartment, performing the following steps will allow air to flow through the instrument panel outl ...

    Entering the vehicle following remote engine start shutdown
    An alarm trigger may occur if the vehicle is opened by the remote keyless entry transmitter within a few seconds immediately following remote engine start shutdown. ...

    Bulb chart
    NOTE Lights A and B are the LED (Light Emitting Diode) type. Consult your SUBARU dealer for replacement. WARNING Bulbs may become very hot while illuminated. Before replacing bulbs, turn of ...