To set cruise control

1. Push the “CRUISE” main switch button.

1. Push the “CRUISE” main switch button.

Non-turbo models
Turbo models

The cruise control indicator light on the combination meter will illuminate.
Non-turbo models

The cruise control indicator light on the combination meter will illuminate.

2. Depress the accelerator pedal until the vehicle reaches the desired speed.

3. Push the “SET/COAST” button and release it. Then release the accelerator pedal.

3. Push the “SET/COAST” button and release it. Then release the accelerator pedal.

Non-turbo models
Turbo models

At this time, the cruise control set indicator light is illuminated on the combination meter.
Non-turbo models

At this time, the cruise control set indicator light is illuminated on the combination meter.

The vehicle will maintain the desired speed.

Vehicle speed can be temporarily increased while driving with the cruise control activated. Simply depress the accelerator pedal to accelerate the vehicle.

When the accelerator pedal is released, the vehicle will return to and maintain the previous cruising speed.

    See also:

    Low beam light bulbs
    Right-hand side 1. Use a screwdriver to undo the clips on the air intake duct, then remove the air intake duct (right-hand side). Left-hand side 2. Use a screwdriver to remove the secured clip of t ...

    Garage door opener programming in the U.S.A.
    NOTE When programming the HomeLink® Wireless Control System for a garage door opener, it is suggested that you park the vehicle outside the garage. 1. Unplug the motor of the garage door opener from ...

    Valet mode
    When you choose the valet mode, the alarm system does not operate. In valet mode, the remote transmitter is used only for locking and unlocking the doors and rear gate (Outback) and panic activati ...