Setting passkey

1. Select the “SET PASSKEY” menu by operating the “TUNE/TRACK/CH” dial.

After the currently set passkey is displayed, a new passkey can be entered.

2. Input the new passkey by operating the “TUNE/TRACK/CH” dial.

3. Select the “CONFIRM” menu by operating the “TUNE/TRACK/CH” dial. The new passkey is displayed, the passkey is changed and the mode changes to the Bluetooth® audio setting mode.

    See also:

    Parking on a grade
    Always block the wheels under both vehicle and trailer when parking. Apply the parking brake. You should not park on a hill or slope. But if parking on a hill or slope cannot be avoided, you shoul ...

    Immobilizer system
    This light blinks approximately 60 seconds after the ignition switch is turned from “ON” position to the “Acc” or “LOCK” position or immediately after the key is pulled out. Refer to “Immobilizer” ...

    Breaking-in of new brake pads and linings
    When replacing the brake pad or lining, use only genuine SUBARU parts. After replacement, the new parts must be broken in as follows: ...