Registering (pairing) device

1. Select the “PAIR AUDIO” menu by operating the “TUNE/TRACK/CH” dial. If a device is already registered, “MEMORY FULL” is displayed and the mode changes to the Bluetooth® audio setting mode.

2. After the passkey is shown on the display, input the passkey into the cell phone. If you input the correct passkey, “PAIRED” is displayed and the registering procedure is finished. If you input an incorrect passkey, “FAILED” is displayed, the registering procedure was not successful and the mode changes to the Bluetooth® audio setting mode.

    See also:

    Front turn signal light
    NOTE It may be difficult to replace the bulbs. We recommend that you have the bulbs replaced by your SUBARU dealer if necessary. 1. Turn over the protective cover of the engine compartment. 2 ...

    Channel scan
    Type A and B audio Type C audio Press the “SCAN” button to change the radio to the SCAN mode. In this mode, under the selected category, the radio scans through the channel until a station is found. ...

    Hands-free system (if equipped)
    NOTE - For models with the genuine SUBARU navigation system, refer to the Owner’s Manual supplement for the navigation system. - When selling your vehicle, make sure that you initialize the ...