Odometer/Trip meter

Non-turbo models
Turbo models

1) Trip knob
Non-turbo models

1) Trip knob

This meter displays the odometer and two trip meters when the ignition switch is in the “LOCK”, “Acc” or “ON” position.

If you press the trip knob when the ignition switch is in the “LOCK” position, the odometer/trip meter will light up. It is possible to switch the indications while the odometer/trip meter is lit up. If you do not press the trip knob within 10 seconds of illumination of the odometer/trip meter, the odometer/trip meter will turn off.

The display can be switched as shown in the following illustration by pressing the trip knob.

*1: STI only

*1: STI only
*2: , and or or, and cannot be displayed when the ignition switch is in the “ON” position. or *3: Turbo models except STI cannot be displayed when the ignition switch is in the “ON” position.
*3: Turbo models except STI

See also:

Control panel
Control panel 1) Temperature control dial (driver’s side) 2) AUTO button 3) DUAL mode button 4) OFF button 5) Air inlet selection button 6) Fan speed control button 7) Airflow mode sele ...

Daytime running light system
WARNING The brightness of the illumination of the high beam headlights is reduced by the daytime running light system. The light switch must always be turned to the “” position when it is dark ou ...

Changing the coolant
WARNING Never attempt to remove the radiator cap until the engine has been shut off and has cooled down completely. Since the coolant is under pressure, you may suffer serious burns from a spray ...