System servicing

• When discarding a seatbelt retractor assembly or scrapping the entire vehicle damaged by a collision, consult your SUBARU dealer.

• When discarding a seatbelt retractor assembly or scrapping the entire vehicle damaged by a collision, consult your SUBARU dealer.

• Tampering with or disconnecting the system’s wiring could result in accidental activation of the seatbelt pretensioner and/or SRS airbag or could make the system inoperative, which may result in serious injury. Do not use electrical test equipment on any circuit related to the seatbelt pretensioner and SRS airbag systems. For required servicing of the seatbelt pretensioner, consult your nearest SUBARU dealer.

The front sub sensors are located on both the right and left sides at the front of the vehicle, and the SRS airbag control module including the impact sensors is located under the center console. If you need service or repair in those areas or near the front seatbelt retractors, have the work performed by your authorized SUBARU dealer.

The front sub sensors are located on both the right and left sides at the front of the vehicle, and the SRS airbag control module including the impact sensors is located under the center console. If you need service or repair in those areas or near the front seatbelt retractors, have the work performed by your authorized SUBARU dealer.

NOTE
If the front part of the vehicle is damaged in an accident to the extent that the seatbelt pretensioner does not operate, contact your SUBARU dealer as soon as possible.

    See also:

    To open and close the trunk lid from outside
    The trunk lid can be opened using the remote keyless entry system. Refer to “Remote keyless entry system”. To close the trunk lid, lightly press the trunk lid down until the latch engages. NOTE Do ...

    When you do not tow a trailer
    ● Remove the ball mount from the hitch receiver tube and insert the receiver cover onto the hitch receiver tube. ● Place the dust cap over the four-pin connector of the hitch wire harne ...

    How to preset channels
    1. Press the “SAT” button to select SAT1, SAT2 or SAT3 reception. 2. Select the desired channel. 3. Press one of the preset buttons (from to ) for more than 1.5 seconds to store the channel ...