Use of engine braking

Remember to make use of engine braking in addition to foot braking. When descending a grade, if only the foot brake is used, the brakes may start working improperly because of brake fluid overheating, caused by overheated brake pads. To help prevent this, shift into a lower gear to get stronger engine braking.

    See also:

    Tone and balance control (type A, B and C audio)
    Each brief press of the “TUNE/TRACK/ CH” dial changes the control modes in the following sequence. Choose the preferred level for each mode by turning the “TUNE/TRACK/CH” dial. The control ...

    Hill start assist system (MT models – if equipped)
    The Hill start assist system is a device only for helping the driver to START the vehicle on an uphill grade. To prevent accidents when the vehicle is parked on a slope, be sure to firmly set the ...

    To increase the speed (by the “RES/ SET” switch)
    Press the “RES/SET” switch to the “RES” side and hold it until the vehicle reaches the desired speed. Then, release the switch. The vehicle speed at that moment will be memorized and treated as ...