Selecting phone
To select the registered cell phone for connecting to the in-vehicle equipment, perform the following procedure.
1. Select the “SELECT PHONE” menu. If no cell phones are registered, “EMPTY” is displayed and the mode changes to the “PHONE SETUP” mode.
2. Select the cell phone by operating the “TUNE/TRACK/CH” dial or saying the voice tag.
3. Select the “CONFIRM” menu (only after saying the voice tag). “SELECTED” is displayed, the selected cell phone is connected to the in-vehicle equipment and the mode changes to the “PHONE SETUP” mode.
See also:
Gasoline for California-certified LEV
If your vehicle was certified to California’s
low emission vehicle (LEV) standards as
indicated on the underhood tune-up label,
it is designed to optimize engine and
emission performance with ...
Snow tires
WARNING
● When replacing original tires with winter (snow) tires, make sure you use only
the same size, construction and load range as the original tires listed on the tire
placard. Using o ...
Valet mode
When you choose the valet mode, the alarm system does not operate. In valet mode,
the remote transmitter is used only for locking and unlocking the doors and rear
gate (Outback) and panic activati ...