Reprogramming a single HomeLink® button

1. Press and hold the HomeLink® button you wish to reprogram. DO NOT release the button until step 4 has been completed.

2. When the HomeLink® indicator light begins to flash slowly (after approximately 20 seconds), position the hand-held transmitter of the device between 1 to 3 inches (25 to 76 mm) away from the HomeLink® button you wish to program.

3. Press and hold the hand-held transmitter button. The HomeLink® indicator light will flash, first slowly and then rapidly.

4. When the indicator light begins to flash rapidly, release both buttons.

The programming for the previous device is now erased and the new device can be operated by pressing the HomeLink® button.

    See also:

    PRACTICALITY AND STORAGE
    The cabin of the Subaru Outback is longer, wider and taller than that of its predecessor, allowing improvements to be made in comfort and practicality. The interior also demonstrates lessons learn ...

    Front seatbelts
    1. Adjust the seat position according to the following procedure. Driver’s seat: Adjust the seatback to the upright position. Move the seat as far from the steering wheel as practical while sti ...

    Cruise control indicator light
    The cruise control indicator light illuminates when the ignition switch is turned to the “ON” position and turns off after approximately 3 seconds. This light illuminates when the “CRUISE” main s ...