Activating and deactivating the alarm system
To change the setting of your vehicle’s alarm system for activation or deactivation, do the following.
1. Disarm the alarm system. Refer to “Disarming the system”.
2. Sit in the driver’s seat and shut all doors and the rear gate.
3. Turn the ignition switch to the “ON” position.
4. Hold down the UNLOCK side of the driver’s power door locking switch, open the driver’s door within the following 1 second, and wait 10 seconds without releasing the switch. The setting will then be changed as follows.
If the system was previously activated:
The odometer/trip meter screen displays “AL oF” and the horn sounds twice, indicating that the system is now deactivated.
If the system was previously deactivated:
The odometer/trip meter screen displays “AL on” and the horn sounds once, indicating that the system is now activated.
NOTE
You may have the above setting
change done by your SUBARU dealer.
See also:
Type C audio set (if equipped)
Type C audio set (if equipped)
The audio set will operate only when the ignition switch is in the “Acc” or “ON” position.
• Power and sound controls
• Radio operation
• Satellite radio operation ( ...
Tilt/telescopic steering wheel
- Do not adjust the steering wheel
tilt/telescopic position while driving.
This may cause loss of
vehicle control and result in
personal injury.
- If the lever cannot be raised to
the fi ...
Air filtration system
Replace the filter element according to the
replacement schedule as follows. This
schedule should be followed to maintain
the filter’s dust collection ability. Under
extremely dusty conditions ...
