Locking and unlocking from the outside

NOTE
If you unlock the driver’s door with a key and open the door while the alarm system is armed, the alarm system is triggered and the vehicle’s horn sounds. In this case, perform any of the following operations:
- Press any button on the remote transmitter.

- Insert the key into the ignition switch and turn the ignition switch to the “ON” position.

For details about the alarm system, refer to “Alarm system”.

To lock the driver’s door from the outside

To lock the driver’s door from the outside with the key, turn the key toward the rear.

To unlock the door, turn the key toward the front.

Pull the outside door handle to open an unlocked door.

1) Rotate the lock lever rearward.

1) Rotate the lock lever rearward.

2) Close the door.

To lock the door from the outside without the key, rotate the lock lever rearward and then close the door.

To lock the door from the outside using the power door locking switch, push the front side of the switch (“LOCK” side) and then close the door. In this case, all closed doors and the rear gate are locked at the same time.

Always make sure that all doors and the rear gate are locked before leaving your vehicle.

NOTE
Make sure that you do not leave the key inside the vehicle when locking the doors from the outside without the key.

    See also:

    HomeLink® Wireless Control System
    The HomeLink® Wireless Control System can be used to activate remote control devices such as gate operators, garage door openers, door locks, home lighting and security systems. There are three H ...

    Gross Vehicle Weight (GVW) and Gross Vehicle Weight Rating (GVWR)
    Gross Vehicle Weight The Gross Vehicle Weight (GVW) must never exceed the Gross Vehicle Weight Rating (GVWR). Gross Vehicle Weight (GVW) is the combined total of the weight of the vehicle, dri ...

    Windshield wiper blade rubber
    1) Support 1. Grasp the locked end of the blade rubber assembly and pull it firmly until the stoppers on the rubber are free of the support. 1) Metal spines 2. If the new blade rubber is ...