Windshield wiper blade assembly
1. Raise the wiper arm off the windshield.
1) Open the cover
2) Pull down the wiper blade
2. Remove the wiper blade assembly by opening the cover and pulling it down in the direction shown in the illustration.
3. Install the wiper blade assembly to the wiper arm. Make sure that it locks in place.
4. Hold the wiper arm by hand and slowly lower it in position.
See also:
Parking in cold weather
Do not use the parking brake when
parking for long periods in cold weather
since it could freeze in that position.
Instead, observe the following.
1. Place the shift lever in the “1” or “R”
po ...
Checking the clutch pedal free play
1) 0.19 – 0.44 in (5 – 11 mm)
Lightly press the clutch pedal down with your finger until you feel resistance,
and check the free play.
If the free play is not within proper specification, contac ...
To install the cover housing
1. Shorten the bar.
2. Insert the projections located on the both ends of the sleeve into the recesses of the retainers. ...