Drive belts
It is unnecessary to check the deflection of the drive belt periodically because your engine is equipped with an automatic belt tension adjuster. However, replacement of the belt should be done according to the maintenance schedule in the “Warranty and Maintenance Booklet”. Consult your SUBARU dealer for replacement.
If the belt is loose, cracked or worn, contact your SUBARU dealer.
See also:
Gasoline for California-certified LEV
If your vehicle was certified to California’s
low emission vehicle (LEV) standards as
indicated on the underhood tune-up label,
it is designed to optimize engine and
emission performance with ...
4-door models
1. Remove the clip from the rear trunk trim with a screwdriver.
2. Open the rear portion of the side trunk trim panel.
1) Brake/tail and rear side marker light
2) Rear turn signal light
3) Bac ...
Driving on grades
- Before going down a steep hill, slow
down and shift into lower gear (if necessary,
use 1st gear) in order to utilize the
engine braking effect and prevent overheating
of your vehicle’s brake ...