Using a warm water washer
● Keep a good distance of 12 in (30 cm) or more between the washer nozzle and the vehicle.
● Do not wash the same area continuously.
● If a stain will not come out easily, wash by hand. Some warm water washers are of the high temperature, high pressure type, and they can damage or deform the resin parts such as mouldings, or cause water to leak into the vehicle.
See also:
Removing and reinstalling clips
Removing clips
There are several types of clips used for your vehicle
Type A clips
1. Turn the clips counterclockwise using a flat-head screwdriver until the center
portion of the clip is raise ...
Shift-up indicator light (STI)
While selecting the Intelligent (I) mode of SI-DRIVE, this indicator light illuminates and informs the driver about the upshift timing for fuel-efficient driving. ...
Back-up light (5-door)
1. Apply a flat-head screwdriver to the light cover as shown in the illustration, and pry the light cover off from the rear gate trim.
2. Turn the bulb socket counterclockwise and remove it.
3 ...