Headlight flasher

CAUTION


CAUTION

Do not hold the lever in the flashing position for more than just a few seconds.

To flash the headlights, pull the lever toward you and then release it. The high beam will stay on for as long as you hold the lever. The headlight flasher works even though the lighting switch is in the “OFF” position.

When the headlights are on high beam, the high beam indicator light “on the combination meter also illuminates.”
on the combination meter also illuminates.

    See also:

    Mist (for a single wipe)
    Mist (for a single wipe) For a single wipe of the wipers, pull the lever toward you. The wipers operate until you release the lever. ...

    Defogger and deicer
    1) Rear window defogger 2) Outside mirror defogger (if equipped) 3) Windshield wiper deicer (if equipped) The vehicle is equipped with a rear window defogger. Some models are also equipped with ...

    High beam light bulbs
    Right-hand side 1. Use a screwdriver to undo the clips on the air intake duct, then remove the air intake duct (right-hand side). 2. Disconnect the electrical connector from the bulb. 3 ...