Vehicle Dynamics Control warning light

CAUTION

The Vehicle Dynamics Control system provides its ABS control through the electrical circuit of the ABS system. Accordingly, if the ABS is inoperative, the Vehicle Dynamics Control system becomes unable to provide ABS control. As a result, the Vehicle Dynamics Control system also becomes inoperative, causing the warning light to illuminate. Though both the Vehicle Dynamics Control and ABS systems are inoperative in this case, the ordinary functions of the brake system are still available. You will be safe while driving with this condition, but drive carefully and have your vehicle checked at a SUBARU dealer as soon as possible.

NOTE

● If the electrical circuit of the Vehicle Dynamics Control system itself malfunctions, the warning light only illuminates. At this time, the ABS (Anti-lock Brake System) remains fully operational.

● The warning light illuminates when the electronic control system of the ABS/Vehicle Dynamics Control system malfunctions.

The Vehicle Dynamics Control system is probably inoperative under any of the following conditions. Have your vehicle checked at a SUBARU dealer immediately.

● The warning light does not illuminate when the ignition switch is turned to the “ON” position.

● The warning light illuminates while the vehicle is running.

NOTE

If the warning light behavior is as described in the following examples, the Vehicle Dynamics Control system may be considered normal.

● The warning light illuminates right after the engine is started but turns off immediately, remaining off.

● The warning light illuminates after the engine has started and turns off while the vehicle is subsequently being driven.

● The warning light illuminates during driving, but it turns off immediately and remains off.

    See also:

    Information display
    Information display 1) Outside temperature indicator 2) Fuel consumption indicator With the ignition switch in the “ON” position, the outside temperature, current fuel consumption (if equipped) and ...

    Ventilation
    Ventilation To force outside air through the instrument panel outlets: 1. Set the air inlet selection button to the OFF position. 2. Set the airflow control dial to the “” position. 3. Set the tem ...

    Band selection
    Type A and B audio Type C audio Push the “SAT” button when the radio is off to turn on the radio. Push the “SAT” button when the radio is on to select SAT1, SAT2 or SAT3 reception. ...