Double trip meter
1) Trip knob
This meter displays the two trip meters when the ignition switch is in the “ON” position.
The trip meter shows the distance that the vehicle has been driven since you last set it to zero.
If you press the trip knob when the ignition switch is in the “LOCK” or “Acc” position, the odometer/trip meter will light up. It is possible to switch between the A trip meter and B trip meter indications while the odometer/trip meter is lit up. If you do not press the trip knob within 10 seconds of illumination of the odometer/trip meter, the odometer/trip meter will turn off. Also, if you open and close the driver’s door within 10 seconds of illumination of the odometer/trip meter, the odometer/trip meter will turn off.
The display can be switched as shown in the following illustration by pressing the trip knob.
To set the trip meter to zero, select the A trip or B trip meter by pressing the knob and keep the knob pressed for more than 2 seconds.
CAUTION
To ensure safety, do not attempt to change the function of the indicator during driving, as an accident could result.
NOTE
If the connection between the combination meter and battery is broken for any reason such as vehicle maintenance or fuse replacement, the data recorded on the trip meter will be lost.
See also:
Map lights
Type A
Type B
To turn on the map light, push the switch.
To turn it off, push the switch again.
When leaving the vehicle, make sure the lights are turned off to avoid battery discharge.
NOTE
For ...
Safety
Still think you can't have it all? Check out the Impreza's crash tests, which
at the time of publication are the best in the Insurance Institute for Highway
Safety's Small Car class, with top scor ...
Fastening the seatbelt
WARNING
● Never use a belt that is twisted or reversed. In an accident, this can increase
the risk or severity of injury.
● Keep the lap belt as low as possible on your hips. In a coll ...