Subaru Outback (BR): Front position light
1. Turn the socket counterclockwise and pull it out.
2. Pull out the bulb from the socket and replace the bulb with a new one.
READ NEXT:
NOTE
It may be difficult to replace the bulbs. We recommend that you have the bulbs
replaced by your SUBARU dealer if necessary.
1. Pull off the fender lining. Refer to “Pulling off the fender l
Legacy
NOTE
It may be difficult to replace the bulbs. We recommend that you have the bulbs
replaced by your SUBARU dealer if necessary.
1. Turn the knobs of the cover 90 degrees counterclockwis
1. Apply a flat-head screwdriver to the light cover as shown in the illustration,
and pry the light cover off from the rear gate trim.
1) Back-up light
2) Tail light
2. Turn the bulb socket c
SEE MORE:
A: REMOVAL
NOTE:
For removal of front reduction driven gear, refer to the "Front Reduction Drive
Gear". <Ref. to CVT-297, REMOVAL,
Front Reduction Drive Gear.>
B: INSTALLATION
NOTE:
For installation of front reduction driven gear, refer to the "Front Reduction
Drive Gear". <Ref. to CVT-29
A: PROCEDURE
CAUTION: When removing or installing, remove all foreign matter (dust, water, and oil) from the electronic parking brake control module connectors.
NOTE:
To check the harness for open or short circuits, shake problem spot or connector.
Refer to "Check List for Inte
© 2010-2024 Copyright www.suoutback.com