Subaru Outback (BR): Headlight
CAUTION
Halogen headlight bulbs become very hot while in use. If you touch the bulb surface
with bare hands or greasy gloves, fingerprints or grease on the bulb surface will
develop into hot spots, causing the bulb to break. If there are fingerprints or
grease on the bulb surface, wipe them away with a soft cloth moistened with alcohol.
NOTE
● If headlight aiming is required, consult your SUBARU dealer for proper adjustment
of the headlight aim.
● It may be difficult to replace the bulbs. We recommend that you have the bulbs
replaced by your SUBARU dealer if necessary.
READ NEXT:
1. Pull off the fender lining. For details, refer to “Pulling off the fender
lining” F11- 7.
2. Remove the bulb cover, by turning it counterclockwise.
3. Disconnect the electrical connecto
1. Remove the air intake duct (right-hand side). For the method to remove the
air intake duct, refer to “Removing air intake duct” F11-7.
Left-hand side
2. Use a screwdriver to remove the se
NOTE
It may be difficult to replace the bulbs. We recommend that you have the bulbs
replaced by your SUBARU dealer if necessary.
1. Turn over the protective cover of the engine compartment.
2
SEE MORE:
A: REMOVAL
NOTE:
When replacing a single part, perform the work
with the engine assembly installed to body. Refer to
"Valve Clearance" for preparation procedures.
<Ref. to ME(H4SO)-29, Valve Clearance.>
When performing the work with the engine installed
to body, the following parts must
A: OPERATION
1) While the ABS sequence control is being performed, the operation of the
hydraulic unit can be checked using
the brake tester or pressure gauge after the hydraulic unit solenoid valve
operation.
2) ABS sequence control can be started by the Subaru Select Monitor.
1. ABS SEQUENCE CO
© 2010-2024 Copyright www.suoutback.com