License plate light

1. Insert a finger into the right side of the license plate light cover, then press once to the left and pull out to remove the cover.

1. Insert a finger into the right side of the license plate light cover, then press once to the left and pull out to remove the cover.

2. Turn the bulb socket counterclockwise and pull out the socket.

2. Turn the bulb socket counterclockwise and pull out the socket.

3. Pull the bulb out of the socket.

4. Install a new bulb.

5. Reinstall the license plate light cover.

    See also:

    Tongue load
    Tongue load WARNING If the trailer is loaded with more weight in the back of trailer’s axle than in the front, the load is taken off the rear axle of the towing vehicle. This may cause the rea ...

    Reclining the seatback (Outback)
    WARNING To prevent the passenger from sliding under the seatbelt in the event of a collision, always put the seatback in the upright position while the vehicle is in motion. CAUTION If the vehi ...

    AUTO button
    FULL AUTO mode operation: When the “AUTO” button is pressed, the indicator light “FULL AUTO” on the display illuminates. In this state, fan speed, airflow distribution, air-inlet control, and a ...