Changing the oil and oil filter

Change the oil and oil filter according to the maintenance schedule in the Warranty and Maintenance Booklet.

The engine oil and oil filter must be changed more frequently than listed in the maintenance schedule when driving on dusty roads, when short trips are frequently made, or when driving in extremely cold weather.

NOTE
Changing the engine oil and oil filter should be performed by a properlytrained expert. It is recommended that you have this service performed by your SUBARU dealer.

1. Warm up the engine by letting the engine idle for approximately 10 minutes to ease draining the engine oil.

2. Park the vehicle on a level surface and stop the engine.

3. Remove the oil filler cap.

Non-turbo models
Turbo models

4. Drain out the engine oil by removing the drain plug while the engine is still warm. The used oil should be drained into an appropriate container and disposed of properly.
Non-turbo models

4. Drain out the engine oil by removing the drain plug while the engine is still warm. The used oil should be drained into an appropriate container and disposed of properly.

Be careful not to burn yourself with hot engine oil.

Be careful not to burn yourself with hot engine oil.

5. Wipe the seating surface of the drain plug with a clean cloth and tighten it securely with a new sealing washer after the oil has completely drained out.

6. Remove the under cover.

Non-turbo models
Turbo models

7. Remove the oil filter with an oil filter wrench.
Non-turbo models

7. Remove the oil filter with an oil filter wrench.

8. Before installing a new oil filter, apply a thin coat of engine oil to the seal.

9. Clean the rubber seal seating area of the bottom of engine and install the oil filter by hand turning. Be careful not to twist or damage the seal.

10. Tighten the oil filter by the amount indicated in the following table after the seal makes contact with the bottom of engine.

 Never over tighten the oil filter because that can result in an oil leak.

Never over tighten the oil filter because that can result in an oil leak.

Thoroughly wipe off any engine oil that has spilled over the exhaust pipe and/or under-cover.

If spilled oil is not promptly wiped up, the oil could cause a fire.

11. Reinstall under cover.

12. Pour engine oil through the filler neck.

For the oil capacity (guideline), refer to Engine oil.

The oil quantity indicated above is only guideline.

The necessary quantity of oil depends on the quantity of oil that has been drained.

The quantity of drained oil differs slightly depending on the temperature of the oil and the time the oil is left flowing out. After refilling the engine with oil, therefore, you must use the level gauge to confirm that the level is correct.

13. Start the engine and make sure that no oil leaks appear around the filters rubber seal and drain plug.

14. Run the engine until it reaches the normal operating temperature. Then stop the engine and wait a few minutes to allow the oil drain back. Check the oil level again and if necessary, add more engine oil.

Be careful not to spill engine oil when adding it. If oil touches the exhaust pipe, it may cause a bad smell, smoke, and/or a fire.

Be careful not to spill engine oil when adding it. If oil touches the exhaust pipe, it may cause a bad smell, smoke, and/or a fire.

    See also:

    Flat tires
    If you have a flat tire while driving, never brake suddenly; keep driving straight ahead while gradually reducing speed. Then slowly pull off the road to a safe place. ...

    Tire replacement
    The wheels and tires are important and integral parts of your vehicles design; they cannot be changed arbitrarily. The tires fitted as standard equipment are optimally matched to the characte ...

    Interior
    While the exterior brings the Legacy cruising into 2010, the interior has me a little worried. It's a nice interior, but the seat upholstery's pattern, which looks like small flames, reminds me of ...