To increase the speed (by accelerator pedal)

1. Depress the accelerator pedal to accelerate the vehicle to the desired speed.

2. Push the “SET/COAST” button once.

Now the desired speed is set and the vehicle will keep running at that speed without depressing the accelerator pedal.

NOTE
If the difference between the actual vehicle speed when the button is pushed and the speed last time you set is less than 4 mph (6.8 km/h), the vehicle speed will be lowered by 1 mph (1.6 km/h). This occurs because the cruise control system unit regards this operation as that intended to decrease the vehicle speed.

    See also:

    Accessory power outlets
    Power outlet below the climate control Power outlet in the center console Power outlet in the cargo area (if equipped) Accessory power outlets are provided below the climate control, in the c ...

    GVWR and GAWR (Gross Vehicle Weight Rating and Gross Axle Weight Rating)
    The certification label attached to the driver’s side doorjamb shows GVWR (Gross Vehicle Weight Rating) and GAWR (Gross Axle Weight Rating). The GVW (Gross Vehicle Weight) must never exceed the GVW ...

    Selection of manual mode
    NOTE Please read the following points carefully and bear them in mind when using the manual mode. • If you attempt to shift down when the engine speed is too high, i.e., when a downshift would push ...