P (Park)
This position is for parking the vehicle and starting the engine.
In this position, the transmission is mechanically locked to prevent the vehicle from rolling freely.
When you park the vehicle, first set the parking brake fully, then shift into the “P” position. Do not hold the vehicle with only the transmission.
To shift the select lever from the “P” to any other position, you should depress the brake pedal fully then move the select lever. This prevents the vehicle from lurching when it is started.
See also:
Tire pressure monitoring system (TPMS) (if equipped)
The tire pressure monitoring system provides the driver with a warning message
by sending a signal from a sensor that is installed in each wheel when tire pressure
is severely low.
The tire pre ...
Security ID plate
1) Key number plate
2) Security ID plate
The security ID is stamped on the security ID plate attached to the key set.
Write down the security ID and keep it in another safe place, not in the veh ...
Use of engine braking
Remember to make use of engine braking
in addition to foot braking. When descending
a grade, if only the foot brake is used,
the brakes may start working improperly
because of brake fluid over ...